Step 1 Remove 6 screws from the locations shown, 4 from the top plate (top photo), 2 from the front arms (next photo).
Step 2 Lift the assembly off of the vehicle and put it aside.
Step 3 Screw the set screw a little into the black collar, slide the collar onto the anti-roll bar to the center, then tighten the set screw.
Step 4 Add set screws to the anti-roll bar pivots, then slide the pivots onto the anti-roll bar up to the ball opening, not extending out of it. Tighten the set screws.
Step 5 Pop the anti-roll bar links onto the pivots.
Step 6 Insert the collar and anti-roll bar into the niche where shown (arrow).
Step 7 Attach the 2 BHCS screws where shown. Tighten them just enough so the the bar is still somewhat free.
Step 8 Attach the links to the balls on the arms.
Step 9 Position the front end assembly in place. Insert the shock eyelets in the arms and fasten with 2 screws.
Step 10 Insert the top plate and fasten with 4 screws. The anti-roll bar is now installed.
![]() |
#91735 Online |